Selleys Araldite Ultra Clear Epoxy Adhesive

For those seamless repair jobs, use Selleys Araldite Ultra Clear epoxy adhesive. With the strength to handle a load of up to 130kgs, this adhesive can be used for many surfaces and repairs. This 2-part glue is stronger than most of its counterparts due to the reaction between the 2 parts when mixed.

Features:

• Chemical reaction between parts makes it stronger.
• Multi-purpose.
• Dries clear and leaves no visible evidence of repair.
• Sets in 5 minutes!
• Can hold up to 130kgs (per cm2 when used on steel).
• Highly water-resistant formula.
• Dries rigid to form a lasting bond.
• Surfaces do not need to fit closely.
• A sturdy, durable bond.
• Resistant to heat, not heatproof.
• Does not turn yellow over time.

Usage:

• Repairing broken glass homeware.
• Temperature above 80°C weaken the bond but it is regained once the temperature drops.
• Any cured product can be made more pliable with heat and scraped off for removal.
• Clamp or tape up for a stronger bond.
• Smaller quantities will allow for flexibility in working times. Large quantities will cure faster.
• For the tube variant, use the correct cap for the correct tube. An incorrect cap will cause the product to harden in the tube.
• For any repositioning, the product will need to be reheated. Make sure the surface is heat resistant, heat up to 150°C in an oven. Once the product seems softer, reposition and let cool. The product will cure again once it reaches room temperature.
• In colder weather, a longer bonding time may work best.
• Replace cap immediately after use so that product does not dry out.
• Fix Jewellery.
• Ornaments or crockery.
• Repair broken toys.
• Mend handbag strap.

Can be used on:

• Plastics (except for Polyethylene, Polystyrene or Polypropylene)
• Rubber
• Crystal
• Metal
• China
• Glass
• Wood
• Leather

How to use:

Tubes:

1. Ensure surfaces are clean and dry.
2. Break the seal for each tube with the spike on top of the cap.
3. Thoroughly mix both parts in equal quantities. Post mixing, it can be used for 3-5 minutes at a temperature of 20°C.
4. Put the mixed component on both surfaces to be put together.
5. Bring them together and apply slight pressure.
6. Make sure that no unnecessary strain is applied on the surfaces for 30 minutes. Use tape or clamps if required. For maximum strength, allow 16 hours.
7. Clean any unused product with acetone and replace the cap.

Syringe Nozzle:

1. Ensure surfaces are clean and dry.
2. Remove the plunger cap and make sure to cut the seal at the tip carefully.
3. Dispense liquid onto a clean surface and thoroughly mix both parts in equal quantities. Post mixing, it can be used for 3-5 minutes at a temperature of 20°C.
4. Put the mixed component on both surfaces to be put together.
5. Bring them together and apply slight pressure.
6. Make sure that no unnecessary strain is applied on the surfaces for at least 30 minutes. Use tape or clamps if required. For maximum strength, allow 16 hours.
7. Clean any unused product with acetone and replace the cap.

Available in 2 sizes: 8ml and 24ml.

Have a look at our wide range of Adhesives and Sealants!